Every time you drive by an overpass, you see the cement-and-steel columns that support the roadway. There could be only a few on a small overpass, or more than a dozen in larger overpasses like the ones at two current projects on Interstate 10 in Pinal County. They usually hold the overpass 15 to 20 ft. above what's below.

What you don't see is just how low they go.

A typical bridge column drops down about 80 ft. underground — about the height of an eight-story building.

Each pier includes a cylinder of rebar steel about 6 to 8 ft. in diameter, woven into a lattice that creates hundreds of squares no more than 1 ft. across. Each of those squares is tied together — by hand — to strengthen the concrete that is poured on top to create what's known as a caisson.

Why so deep? Friction.

The bridge columns are in place not only to hold the overpass up but to keep it steady. It's essential that each overpass be held firmly in place. The deep columns create friction with the surrounding ground, preventing the bridge from moving despite thousands of vehicles crossing a typical overpass every day, and weather bringing rain and crosswinds. Combine 10 or more columns and the friction is enough to hold a bridge steady for decades.

Overpasses like the ones being built today in places like Maricopa and Tucson are built to last 50 years or more. One way to make sure they serve that long is to give them a good foundation. By digging so deep, ADOT is doing just that.

Today's top stories

Protecting Delaware Memorial Bridge

Widespread Catastrophic Damage From Hurricane Awaits Repair Crews in SE States

Flatiron, Dragados JV Set to Finish Major Job in Corpus Christi

JCB Celebrates 20 Years of Engine Making

Robert H. Finke & Sons Holds Open House at New Colchester, Vt. Facility

Snyder Civil Leads Way to Provide Clean Water, Safe Communities, More

Today's Security Tech Helps Contractors Combat Jobsite Theft

Komatsu Company Stores East Holds Open House in Pennsylvania